//ep1.c 
//cypress FX2   68013   simple program to test read and write over EP1
//

//             (C) Marko Cebokli S57UUU  Aug 2006 
//             GNU/GPL licence:  www.gnu.org/licences/licences.html#GPL

//compile:  gcc -lusb ep1.c -o ep1

#include <stdio.h>
#include <usb.h>

int main()
{
struct usb_bus *p;
struct usb_device *q;
struct usb_device *current_device;
usb_dev_handle *current_handle;

unsigned char reset[2]={1,0};
unsigned char buffer[10000];
int er[10];
int endpoint=1;
int i,j,tlen;
FILE *f;
unsigned char s[1024];
int length;
int addr;
int type;
unsigned char data[256];
unsigned char checksum,a;
unsigned int b;

usb_init();
er[2]=usb_find_busses();
er[3]=usb_find_devices();

p=usb_busses;
current_device=NULL;
while(p!=NULL)			//find the CY7C68013
	{q=p->devices;
	while(q!=NULL)
		{if ((q->descriptor.idVendor==0x4b4)&&(q->descriptor.idProduct==0x8613))
			current_device=q;
		q=q->next;}
	p=p->next;}
if (current_device==NULL)
	{printf("\n\nCould not find a CY7C68013\n\n");exit(0);}
fflush(stdout);

current_handle=usb_open(current_device);

er[4]=usb_control_msg(current_handle, 0x40, 0xa0, 0xE600, 0, reset, 1, 1000);     //RESET
sleep(0.1);

f=fopen("ep1_fw.ihx", "r");		//load firmware from intel hex file
if (f==NULL)
	{printf("\n\nCould not find file: ep1_fw.ihx\n\n");exit(0);}
while(!feof(f)){
	fgets(s, 1024, f); /* we should not use more than 263 bytes normally */
	sscanf(s+1, "%02x", &length);
	sscanf(s+3, "%04x", &addr);
	sscanf(s+7, "%02x", &type);
	if(type==0){
		printf("Programming %3d byte%s starting at 0x%04x", length, length==1?" ":"s", addr);
		a=length+(addr &0xff)+(addr>>8)+type;
		for(i=0;i<length;i++){
			sscanf(s+9+i*2,"%02x", &b);
			data[i]=b;
			a=a+data[i];}
		sscanf(s+9+length*2,"%02x", &b);
		checksum=b; if(((a+checksum)&0xff)!=0x00) printf("  ** Checksum bad");
		for(i=addr;i<addr+length;i+=16)
			{tlen=addr+length-i;
			if(tlen>16) tlen=16;
			er[5]=usb_control_msg(current_handle, 0x40, 0xa0, i, 0, data+(i-addr), tlen, 1000);}
		} else 
	if(type==0x01){
		printf("End of file\n");
		} else
	if(type==0x02){
		printf("Extended address?\n"); continue;
		}
	}
fclose(f);

er[6]=usb_control_msg(current_handle, 0x40, 0xa0, 0xE600, 0, reset+1, 1, 1000);   //UNRESET
sleep(0.1);

printf("\n SETCONFIG=%d",usb_set_configuration(current_handle,1));

er[7]=usb_claim_interface(current_handle, 0);
er[8]=usb_set_altinterface(current_handle, 1);

buffer[0]=0x41;buffer[1]=0x42;buffer[2]=0x43;buffer[3]=0x44;buffer[4]=0x45;    //just some numbers

printf("\n Before: ");for (i=0;i<5;i++) printf(" %02x", buffer[i]); printf("\n");

for (j=0;j<10;j++)
	{
	er[9]=usb_bulk_write(current_handle, endpoint, buffer, 5, 1000);   //send 5 bytes
	sleep(0.1);
	er[10]=usb_bulk_read(current_handle, endpoint, buffer, 5, 1000);   //receive 5 bytes
	printf("\n After: ");for (i=0;i<5;i++) printf(" %02x", buffer[i]);
	printf("     status = %d  %d  \n",er[9],er[10]);
	sleep(0.1);
	for (i=0;i<3;i++) buffer[i]--;	   //decrement, to see that data goes both ways each time
	}

usb_release_interface(current_handle, 0);
usb_close(current_handle);

return 0;
}