Subject: Solved checskum update on Sony 2ºGeneration Date: Tue, 19 Jun 2001 00:09:51 +0200 http://www.coastweb.de/dv/dvboard2001/1593.html Posted by Sando Kan on June 18, 2001 at 17:55:55: ------------------------------------------------------------ DV-IN ENABLE HACK FOR THE SONY PC4/PC5 DIGITAL CAMCORDERS (AND CHECKSUM UPDATE FOR OTHER 2ND GENERATION SONY MODELS?) ------------------------------------------------------------ INTRODUCTION These instructions apply to the Sony PC4 and PC5 and maybe to other Sony models that use the same codes. However, the hack that enables checksum changes may also work with other 2nd generation Sony camcorders. Experiment at your own risk. Do not attempt to modify your camcorder if you don't know exactly what you are doing - buy a commercial software or widget instead. I only tested this once and only on one camcorder. Please understand that there is NO guarantee that this information will be accurate for your camcorder. A real Sony RM-95 wired remote was used to gather and test this information, but the various RM-95 PC emulators should work just fine with Sony camcorders. Please note that this is NOT an RM-95 tutorial. If you do not know how to use an RM-95 or an emulator, or if you need info on building a LANC cable for the PC, you can easily find detailed instructions elsewhere on the web. ------------------------------------------------------------ Format of the instructions below: (don't touch your camcorder yet, wait for step 1) 00:01 = go to page 00, address 01 00 -> 01 = change data from 00 to 01 using Data+ or Data- W = write (and of course no "W" means do not write) (W) = not sure if write is required, but I did it and it didn't cause any problems ------------------------------------------------------------ PERMANENT DV-IN ENABLE PROCEDURE 1. Inspect old checksum value: Write down the data values found at 02:F0 and 02:F1 (you may need them later to undo if this doesn't work) The PC4 I tested had 02:F0=23 and 02:F1=04 2. Enable changes on page D: 00:01 00 -> 01 (W) 3. Modify data on page D: 0D:14 24 -> 26 W 0D:2C 12 -> 13 W 4. Inspect new checksum value: Take note of the new values in 02:F0 and 02:F1 (you'll need them in the steps listed below) The PC4 I tested had 02:F0=20 and 02:F1=07 5. Enable checksum update: 00:FF 00 -> 02 00:01 01 -> 80 6. Update checksum value: NOTE: the actual values to be used here are the ones you noted in steps 1 and 4, I had 23 04 for the old checksum and 20 07 for the new one. 0F:FF 23 -> 20 W 0F:FE 04 -> 07 W 7. Disable further changes: 00:FF 02 -> 00 (W) 00:01 80 -> 00 (W) ------------------------------------------------------------ That's it! This worked on a SONY PC4e which now has DV-in enabled in a permanent way. No problems so far, but be warned that the changes above are risky so you may still want to use a commercial widget instead. Many thanks to Helge Wagner, who provided most of this info. Sando Kan June 2001 ------------------------------------------------------------